Teltonika RUT955 LTE 4G Router

Product Information

Note: Firmware version RUT9_R_00.07.01.1 released on 2021.11.22 was removed due to an issue with IPsec tunnel while using mobile connection.

The CA file generated with this option automatically signs the certificates. In short, this option is used for convenience as it doesn't let the user set any additional parameters for the certificate files. Therefore, it should be used only when no other specific requirements are expected. Generating each type of file (excluding 'Simple') requires setting some parameters. This section provides an overview for parameters used in TLS certificate generation. Enables periodic time synchronization for the system using the GPS module which does not require an Internet connection. Improved MODBUS Master service: added multiple datatypes, added multiple register reading for alarms

Panorama Antennas EF-W24 Easyfit WIFI Adhesive Antenna with Reverse Polarity SMA Plug - 3m

FW version RUT9_R_00.07.00 and above will not be supported on legacy-design (RUT955 *7V***) devices. Added validation that prevents automatic connection to first unencrypted WiFi AP when using MULTI AP

Subject information is not mandatory but can be used as user-friendly way to identify the ownership of certificate files by including such information as the owner's location and company name. If you agreed to perform a factory reset, next type in reboot and press "Enter". The router will be reset to it's factory settings and rebooted. The entire sequence of events should look like this: Added the possibility to configure multiple reboot times in one Reboot Scheduler configuration instance Fixed provider information and IMSI value representation when SIM and modem cannot provide this information TCP, UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, HTTPS, FTP, SMTP, SSL v3, TLS, ARP, VRRP, PPP, PPPoE, UPNP, SSH, DHCP, Telnet, SMPP, MQTT, Wake On Lan (WOL)

Teltonika RUT955 4G LTE RS232/RS485 Router

FCC 47 CFR Part 15C (2017), FCC 47 CFR Part 2 (2017), FCC 47 CFR Part 22H (2017), FCC 47 CFR Part 24E (2017), FCC 47 CFR Part 27C (2017) A and ⏚ 1 - ADC input. Analog voltage range: 0-24 V. The input can be configured for 4-20 mA sensor protocol as current measurement (ACL). *