Revell 30ml Decal Soft

Product Information

House of Hobbies may release account information when we believe, in good faith, that such release is reasonably necessary to (i) comply with law, (ii) enforce or apply the terms of any of our user agreements or (iii) protect the rights, property or safety of House of Hobbies, our users, or others.

Decal Solutions - Humbrol DecalFix Reviewing And Testing Decal Solutions - Humbrol DecalFix

Edit @ October 2016: as above, use a spray lacquer. Another gloss coat protects the decal and gives it an even finish which matches the paint underneath. Below is an overview of the decal process, so give it a read and get your models looking as incredible as possible!In the threads I could find on this topic the question of is solvent white vinegar or not came up several times. Now when I smell solvent I don't smell vinegar at all. I DO smell vinegar when I open an old jar of Testors Decal Set, which is used to clean and wet the model surface in preparation for the decal. When I smell both Micro Sol and the Daco product I get a mild Acetone smell. First, although Microsol is not the strongest solution available it can be too much for some decals. I always test on an unwanted decal from any decal sheet to make sure it won't destroy the ones I intend to use on the model. If there is a problem you can always dilute the solution with water. I'd recommend this no matter which of the decal solutions you are using. This is a lesson I learnt the hard way! The latest discussion I could find on this was three years old so I decided rather than replying to it I would start a new topic.

RV39693 REVELL DECAL SOFT 30ML - Modeltune

This type of decal is a little uncommon and should not be confused with water-slide decals or vinyl self-adhesive decals. Wet self-adhesive decals have adhesive on the rear of the decal, which when wet with water, allows the decal to be moved into the correct position before carefully wiping away any access water. This causes the decal adhesive to bond to the model permanently. A small amount of washing up liquid added to the water will help the decal to slide better until you are happy that you have it in the correct position.

Details

Start off by carefully selecting the decal that you are going to place onto your model. Use a fresh hobby knife blade to cut as close to the artwork/lettering as you possibly can, so there is little or none of the unwanted clear vinyl that the self-adhesive decal is printed on. You can use a pair of scissors to cut out the decal, but you may find that a hobby knife is better suited to the task. For any tight curves or areas that the decal needs to conform to that is not flat, you can apply a little heat using a hairdryer set to low (so as not to distort or melt the decal or model part). Once the decal is in place, carefully warm the area with the hairdryer to make the decal soft so that you can push out any creases or bubbles that may have appeared. Edit @ October 2016: nowadays I spray the entire model with a clear lacquer from Halfords (recommended to me by Phil Stutcinskas, a member of the Forge World studio), instead of painting varnish onto the surface where the decal is going to be applied. This protects the model, eliminates brush marks, and ensures an even finish. A layer of gloss varnish provides a smooth surface for the decal to adhere to. Second, the blue Microset bottle looks a LOT like the bottle that the Liquid Decal Film comes in. You do not want to splosh this on your model instead of Microset unless you really want to start painting again! Another lesson learnt the hard way!