FixtheBog 20mm MDPE Outside Tap Kit With Plastic Wall Plate & Garden Hose Fitting DCV

Product Information

You can replace the washer on the outside tap, but sometimes it’s so much easier and less of a headache to just replace the tap.

Garden Taps | Outside Taps | Screwfix Garden Taps | Outside Taps | Screwfix

Once you’ve made it through with the small drill swap for the large bit and then re-drill the hole from the inside. Once about half way through, go outside and drill out the rest of the hole. As said, this will prevent the large drill bit blowing a huge chunk off the face of the outside wall. Step 4 – Fit Isolation Valve and Drain Plug There are a couple of regulations that you need to take into account when fitting your outdoor tap: Once the guttering is fitted and water is able to fill your water butt you can use a simple tank connector, available for all plumbers merchants, to join more water butts together, giving you more storage.

Finally, cut another length of pipe so that it runs up to the hole through the wall. It should be around 10 – 15mm short of the hole to allow for a 90° bend to be fitted. A pipe clip also needs to be fitted along this section. Outside tap fitting can be very straightforward once you have done it a few times and you have the right tools and materials, but learning how to fit an outside tap the correct way is key. The connections are easy to install, as is the installation of gutters and downpipes. In this project on plastic guttering and downpipes you will find information and a video on installing guttering and making joints in downpipes to create a feed for your water butt. Push each olive down to meet the body and then wrap 3 or so layers of PTFE tape around the threads on the body and screw the compression cap up and tighten, making sure the joint for the new pipe branch is straight and level and pointing the right way.

Fitting an Outside Tap or Garden Tap | DIY Doctor

Measure the depth of the hole and cut a suitable length piece of 22mm copper pipe so that it is roughly 10mm shorter than the hole depth so that you have a 5mm inset at either end. Summer’s nearly here (woohoo!) and with that, there are so many more reasons to hang out in the garden. If you don’t have an outdoor tap, it can be a real pain to clean in the garden, water plants, even fill pets’ water bowls. I fitted a garden tap yesterday. Before that I needed to attach a hose to the kitchen tap and run it out the window – not ideal! The outdoor tap took just half an hour to fit and is going to get so much use. Read on to follow the steps. If it freezes and expands inside a pipe it can very easily cause it to burst which can be a nightmare in terms of leaks and also having to repair it.To insatall an outside tap correctly and ensure all works as it should do, you will need the following products and tools: Always start with a small drill first to drill a pilot hole as this takes the strain off the drill trying to drill too large a hole in one go and also when it busts through the wall on the other side it doesn’t blow a huge chunk off. You can buy an outdoor tap kit from most DIY stores, which has everything you need to get your garden tap plumbed in. All you do is drill a hole, attach the tap, and screw the connector onto your pipe, which cuts the pipe and attaches your new pipe to the mains… easy! However, you can only use one of these kits if you have copper pipes. Unfortunately, my water pipes are plastic so I had to find a different way of connecting my tap. It’s worth noting that you can still use this method if you have copper water pipes! Your hose should be fitted with a push-fit hose connector which you can push onto the outside tap connector to attach a hose to a tap. To make sure you have a good supply of water to your water-butt connected system it is a good idea to collect water from any available sources such as gutters and down pipes from your house and any sheds you may have.