Manns Premier UV Decking Oil 5L - Natural Oak - A Multi-Purpose Decking Oil, That Protects Against Weathering & UV Damage

Product Information

We are set up to do a big deep clean with oxygen bleach and want to apply something that is as indestructible, low maintenance and long lasting as possible. Basically hoping to get it done and forget about it for as many years as possible! Its a bit of a battle to maintain the natural colour of these types of woods I am afraid, they will just naturally silver and for many people this is the desired result. It is a balancing act to get the best for the wood, protection or colour.

Always, stir the contents of the tin thoroughly, at least for a couple of minutes before applying. This ensures that colour pigments and other important ingredients of the product are well distributed and not concentrated at the bottom of the tin. Thank you for getting in touch with your question. It is a common question asked for beautiful tropical hard woods such as Ipe, Balua and Iroko. Jatoba is a less common one, however if it is anything like the others it will require a period of weathering. Tropical hardwoods tend to have a naturally high oil content when they are relatively new, these oils will prevent the uptake or adhesion of any product that you try to apply. So a weathering period to allow these oils to naturally disperse is the recommendation.But what about the colour. This is meant to be truly clear in spite of the UV protection, and the UV protection in all these oils and water based products is like a pair of sunglasses protecting the wood, which tends to involve the introduction of a pigment that can give the wood a yellow or other tint. An oil soaks into the surface of the wood and will wear away over time. A stain, paint or varnish is a surface sealer and over time could peel and flake, exposing bare wood underneath. Paint, stains or varnishes can be removed with a stripper such as Paint Panther Paint and Varnish Remover. Oils unfortunately can not and if you can’t wait for them to wear away naturally the you can use a pressure washer to remove much of it, care must be taken not to damage the wood however. Having recently used Remmers Douglas Fir Oil on my garden furniture, I found it to be an excellent choice for protecting and preserving the wood. It’s an eco-friendly option with the EU Ecolabel award, and that’s important to me as I try to make more sustainable choices in my day-to-day life.

A little goes a long way and it is likely that you will only need the 125ml tin of each colour to complete your project, although this is dependent on the size of the sculpture and the condition of the wood, for example if it is particularly dry the uptake of oil will be more. Test areas are vital to ensure you like the colour that will be achieved.One other thing to bare in mind is if the fence is rough sawn it will absorb far more of the product that the recommended guidelines and so give a more intense colour. Customer review:"Last used 2 years ago and finish lasted well. Very good product and so simple to apply by brush. Slightly more expensive but would recommend for quality."

It would need a little bit of experimentation first to get the right result, it may be that you only require a very small amount of the coloured oil added to the clear, it is vital to thoroughly mix them together. So small ratio measures first and tests on your wood, until you get the desired result and then you are able to mix up a larger quantity in the same ratio to complete the project. This will help you to control the colour a bit more for getting the lighter result. Ahandytip before we get started is to keep an eye on the weather forecast as we are going to need a couple of clear days to get the project done properly trust me it’ll be worth it in the end. As the wood is Balau there may be a naturally high oil content already and a test area first to ensure the wood will accept further oil is strongly recommended. You could wipe down the surface of the wood with Methylated spirits first as this will encourage the wood to accept more oil. Then two thin coats are all that is required. Resistant to changeable weather conditions, general wear and tear, prevents wood from greying and splitting. As I’ve discovered, some oils offer better water resistance, while others provide enhanced UV protection. The appearance of the finish, such as matte or glossy, is also worth considering when making my decision.A slight concern I had was the tendency of the product to clog when left in a spray applicator. However, with a bit of cleaning and attention, it can still be used effectively in this manner. Also oiled finishes although dry and ready to use after 24 – 48 hours continue to cure and get more durable for days and weeks following application. Covering will prevent the natural curing process from occurring and this is one of the reasons we do not recommend putting rugs over and oiled floor for the first month. However, specific information about the ease of application and enhanced appearance is not provided for the Manns Premier UV in the given details. Depending on individual needs and preferences, customers may prioritize the UV protection and weather resistance provided by the Manns Premier UV 5L Clear or the comprehensive features of the RONSEAL Ultimate Natural 5L, including its natural look and unique penetrating formula. Different species of wood will absorb oils at a different rate and in turn the pigment and so you will get the same tone but perhaps with a slight variance in intensity of colour. Test areas will show what colours can be achieved. Bauer Consumer Media Ltd, Company number 01176085; Bauer Radio Limited, Company number: 1394141; Registered office: Media House, Peterborough Business Park, Lynch Wood, Peterborough PE2 6EA and H Bauer Publishing, Company number: LP003328; Registered office: The Lantern, 75 Hampstead Road, London NW1 2PL