TP-LINK TL-WR802N - wireless router - 802.11b/g/n - desktop(TL-WR802N)

Product Information

MTU(Bytes) - The default MTU size is 1500 bytes. It is not recommended that you change the default MTU size unless required by your ISP. MTU(Bytes) - The normal MTU (Maximum Transmission Unit) value for most Ethernet networks is 1500 Bytes. For some ISPs, you may need to modify the MTU. But this is rarely required, and should not be done unless you are sure it is necessary for your ISP connection. How to setup Local and Remote Management rules on TL-WR802N/WR810N (standard router and hotspot router mode-new logo) 06-27-2022 35563 IMPORTANT: To prevent upgrade failures, please read the following before proceeding with the upgrade process

Select Allow the stations specified by any enabled entries in the list to access as the filtering rule.Connect on Demand - In this mode, the internet connection can be terminated automatically after a specified inactivity period (Max Idle Time) and be re-established when you attempt to access the internet again. If you want to keep your internet connection active all the time, please enter 0 in the Max Idle Time field. Otherwise, enter the number of minutes you want to have elapsed before your internet access disconnects. This function allows you to enable IPv6 function and set up the parameters of the router’s Wide Area Network (WAN) and Local Area Network (LAN). MTU(Bytes) - The normal MTU (Maximum Transmission Unit) value for most Ethernet networks is 1500 Bytes. It is not recommended that you change the default MTU size unless required by your ISP. Select Schedule in the drop-down list of Enable Auto Reboot and specify the Time when the router reboots and Day which to decide how often it reboots.

When using this guide, please notice that features of the router may vary slightly depending on the model and software version you have, and on your location, language, and internet service provider. All screenshots, images, parameters and descriptions documented in this guide are used for demonstration only. With the router powered on, press and hold the Reset button until the LED blinks and then release the button. If the service you want to use is not in the Common Service Port list, you can enter the corresponding parameters manually. You should verify the port number that the service needs.

Flexible Power Supply - Find Power Wherever You Are

Port Range - The port range which the Interior PC access the outside PC. If all are blank or 0, the domain is noneffective. If using a cable modem, unplug the Ethernet cable and reboot the modem. Wait until its Online LED is on and stable, then reconnect the Ethernet cable to the modem. How to configure Virtual Servers on TL-WR802N/WR810N (standard router and hotspot router mode-new logo) 06-27-2022 31307 Enable Client Isolation - This function isolates all connected wireless stations so that wireless stations cannot access each other through WLAN. This function will be disabled if WDS/Bridge is enabled. How to configure Parental Controls on TL-WR802N (standard router and hotspot router mode-new logo) 06-27-2022 33200