TP-Link JetStream 24-Port Gigabit L2 Managed Switch with 4 SFP Slots, Supports 24 Gigabit RJ45 ports, Rackmount (TL-SG3428)

Product Information

After entering part of a command, you can press the TAB key or a question mark (?) then the switch will automatically complete the command. If your input corresponds to more than one command, the switch will not auto-complete but will display all related commands. A querier periodically sends a general query on the network to solicit membership information and sends group-specific queries when it receives leave messages from hosts.

You can use the Auto-Completion feature to enter a complete command, you can also enter part of the command without completion, and the switch will recognize and execute the command automatically.The switch supports configuring IGMP Snooping on a per-VLAN basis. After IGMP Snooping is enabled globally, you also need to enable IGMP Snooping and configure the corresponding parameters for the VLANs that the router ports and the member ports are in. The command is “ip igmp snooping vlan-config vlan-id”. After you finish the configurations, don't forget to save them, otherwise, they will be lost if you power off or reboot the switch. If your computer has a serial port (COM), please connect it to the console port (RJ45) of the switch, with the RJ45 console cable. Using the Omada SDN Controller to Manage Omada Devices Across Multiple Locations Via a Controller (5.0 and Above) 05-31-2023 20224 What should I do when the Omada Software Controller (V4) fails to discover the devices? 11-23-2021 87590

How to Configure Management VLAN on TP-Link Smart and Managed Switches Using the New GUI 04-26-2023 25766What's the difference between Master Administrator, Administrator and Viewer account in Omada Controller? 04-20-2023 16282 Normally, all switch ports are member ports of VLAN 1. If you do not want to remove a port from VLAN 1, you need to additionally configure it.

For example, the show command can display information about many functions, you can enter the following command to view all the information that the show command can print, note that there is a space before the question mark, otherwise it is auto-completion.Use the enable command to enter this mode from User EXEC mode, which allows more commands such as “configure”. How to configure IGMP Snooping for IPTV network on L2 Managed switches using the new GUI 06-27-2022 139402