Guitar Hero X-Plorer Wired Guitar Controller (Xbox 360)

Product Information

Somewhat uncommonThis is more because the xplorer is one of the most sought after guitars, but these are very uncommon at thirft stores. Note that in a future version, there will be some Pi pico only features, such as support for the WT Tap bar, and support for controller authentication passthrough, for XB1, retail XB360 and PS4. For a comprehensive overview of compatibility and requirements, please review the community maintained spreadsheet. If you have questions about how to bind your controls, please see the controls section of the manual. VCC (voltage common connector) - this is where you would connect to provide power to a circuit. Sometimes this pin is labelled as 3.3V or 3v3 on the microcontroller or pinout.

While many guitars will work with Clone Hero, there are a select few that we recommend for users. These guitars are either of high quality, known to work, or are otherwise preferable to the alternatives that may be available.Besides the above, it doesn’t matter which pins you choose when wiring up your guitar, as the Config Tool will be configured later with the pins you use. Wiring Steps If your Pico is NOT an offical pi pico, you may need to use the KB2040 if your pico board is not listed, as the offical pi pico firmware is strict on its support and may not work with your hardware. If you find that you are unable to use your pico after unplugging and replugging it, this is the problem. If you are unable to navigate the main menu, be sure that you have pressed start and selected a profile before any trouble shooting. On keyboard, you will press ENTER and then us the A key to "Accept" and the S key to "Cancel" by default.

Xbox One: Requires a generic Xbox One controller receiver and additional software. Please see the Xbox One Wireless Receiver entry in Receivers and Dongles for more information.With most whammy's there are 3 pins. (if there are 4, you do not need the fourth. 2 pins is discussed below) The middle pin is the data pin, one outer pin is VCC while the other pin is GND (it doesn't matter which one, you can flip it when programming later if needed). Whammy needs to go to an analogue pin.