Introducing Enclosure for Ring DIN Rail Transformer (2nd Gen) and Ring DIN Rail Transformer (1st Gen)

Product Information

The Ring app connects your Ring Doorbell to your mobile device running iOS or Android, making sure you’re always home. Search for “Ring” in one of the app stores above, or to automatically find the correct app, visit ring.com/app. Traditional DIN Rail transformers are 35 mm wide. The Ring DIN Rail Transformer can be removed from its housing to be a more compact 17.5 mm. Attach your existing doorbell wires to the terminals on the rear of your Video Doorbell, and tighten the terminal screws with the Ring screwdriver.

Open the Ring app and tap Set Up Device to begin the setup process. Select Ring Video Doorbell Pro from the list and follow the in-app instructions. Remove the wires that run through your doorbell’s solenoid (again, 0 and 3 in this example), and straighten the ends. Then, firmly insert the wires into the Bypass Mode holes on Pro Power Kit. It doesn’t matter which wire goes to each hole. In some cases, your doorbell transformer may integrated into your internal doorbell. In this configuration, mains power runs from your fusebox directly to the transformer in your doorbell. To replace this type of transformer, make sure that your main power switch is off, then install the Ring transformer in your fusebox. Next, connect mains power to its 240 volt inputs.

What are DIN Rail & Panel Mount Transformers?

Permanently fails to function during overload or short-circuit presenting no danger to the user or surroundings. It may take a moment for your Video Doorbell Wired to power on. You'll know it's ready when it lights up and speaks. 14. Secure your Ring Video Doorbell using screw in bag B If you are replacing a Ring doorbell, align the two small screw holes with two of the existing holes in your wall (fig 2). Note: If you are running the wire up your wall (instead of through it) DO NOT over-tighten the screws. 13. Restore power at the consumer unit Here you can see a small wire on the right side. This is joining the two cables together, so this is not the side that connects to the doorbell mechanism. Join the wires together

If you haven’t already, mount and set up your Ring Video Doorbell according to the instructions provided with your doorbell. Using a transformer to supply a lower load than the nominal power reduces the power loss containing the temperature rise of a bell transformer used continuously. Loop one doorbell wire around each of the screw terminals on the rear of your Ring doorbell, then tighten the terminals to secure. If your doorbell wires are too short to reach your new Ring doorbell, you can attach the included wire extenders using the included wire nuts. Your transformer is most likely in your fusebox or consumer unit. If not, look in other places where electrical components are installed. It may also be inside your existing doorbell. You can often get a clue to the location of the transformer by looking under the cover of your internal doorbell.

Tech Specs

Note: Do not use any screw other than the included long mounting screws when securing your Ring doorbell. This can be done by turning off the mains power switch, or by turning off the power coming into your home at your electric meter. WARNING: Professional installation recommended. Turn off the power to your existing doorbell first.