Angler Fish Adult Fancy Dress Costume

Product Information

I soldered those wires to the battery box of the LED case to connect them in parallel so the voltage across the LEDs would remain the same.

A single bulb is placed into the end of each tube and connected to a 3V AA power source using speaker wire (I highly recommend using red and black colored wire to keep things organized). Each bunch should then be stuffed into a short section of plastic tubing approximately 2 inches long.This diverse selection of costumes and accessories are all artfully designed and expertly crafted by our talented team of artists, designers, and developers. I then slid some coiled spring things I had from a cheap-o broken mini-tripod onto the wire and bent the remaining end into a curved piece. To carve the foam I need to stabilize the whole set up so I screwed the stand down to a sheet of plywood to increase the base area. My wife is a fan of couples costumes so I had to take it up a notch with the king of all deep sea creatures. On both the inside and outside of the hole that the cable runs through I glued in T-bolts to prevent the cables from slicing through the foam.

Be sure to cut the jaw large enough to both get a head through to put the costume on and to make a big mouth for the large teeth. After I had tested all of the circuits and connected them to batteries it was time to wire everything into a switch panel. Again with polystyrene I sculpted a foam block in the shape of the fish's profile and carved it to the appropriate size and shape. Some can grow up to three feet long and weigh up to one hundred pounds (that tops the list of Things You Don't Want to See While Scuba Diving).Bending the hollow steel tube is easy with a pipe bender- without it, you may have to get a little creative with leverage.