The Bestway brand debuted in the mid-1990s, while the Lay-Z-Spa brand didn’t debut until the early 2000s. Since then, they’ve been in charge of thoroughly investigating all of the new technology that has resulted. One of their aircraft is the airjet. Another feature is the rapid heating mechanism, as well as the typical inner and outer liner combination that allows their product to circulate air throughout the tub. Dip a ClearWater® Test Strip in the centre of your Lay-Z-Spa, remove and hold it still for 15 seconds. This TA Increaser helps raise Total Alkalinity levels, which in turn will help control pH levels and chlorine. Make sure that any outdoor storage of chemicals is as far away from your hot tub as possible and in a dry, covered area. Humidity or even small amounts of water can cause chemical reactions that could lead to dangerous fumes. Less than 15 minute set up and we are being generous. The manufacturer states 10 minutes. Do it with the DVD and they are likely right.

With one of the largest capacities available from this brand, and the most amount of airjets possible, you can expect one of the most high-quality hot tubs on the market, though the price tag will reflect that statement.If you are going away we would suggest emptying the hot tub and cleaning it so the water is not left to go stagnant. Do not re-fill until you return from your trip. In the event of spillage, clean up using clean receptacles and dispose of carefully. Do not add water to spilled materials. Do not use floor sweeping compounds to clean up spills. Sweep and scoop spilled material into clean, dedicated equipment. When you’re ready to begin mixing your chemicals, you should handle them with chemical resistant gloves. The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. It is also advised to wear tightly sealed goggles and appropriate protective clothing such as long sleeves, trousers, and closed-toed shoes that fully protect your feet from spills. You should also wash your hands after handling chemicals. In this section, we have tried to answer some of the most commonly asked questions we get about this model of Lay-Z-Spa hot tub. Have a read through and, if you still need help, feel free to get in touch. Q) Do I have to turn the bubbles off to turn the heat on in my inflatable hot tub?

Surprisingly, Lay-Z-Spa was one of the first inflatable hot tub producers to achieve dual functionality. They were present at the beginnings of the heating + bubbles revolution, which began only a decade ago. For a company with nearly three decades of experience, we expect to see a lot more in the future. Do not eat, drink or smoke when using this product. Have a First Aid Kit available for any accidents Clearwater Foam Remover is designed to control and prevent foaming in your hot tub, which is typically caused by the reaction of water with shampoos, deodorants and natural body oils present on the user. Never mix different chemicals in concentrated forms. This includes the kit products but also with other products like bleach or weedkillers – a dangerous reaction may occur.Not balancing the Total Alkalinity levels in your hot tub can cause a number of issues that can impact your spa experience. Because pH measures how acidic or alkaline your water is, it is important to make sure your hot tub ph Levels are always balanced between 7.2 and 7.6 to avoid impacting your Lay-Z-Spa and your spa experience. Similar to earlier versions, Lay Z Spa has created another durable and sturdy Inflatable Hot Tub by combining Tri-tech material with I-beam structure. Lay Z Spa’s Tri-tech material is one of the most durable and comfortable fabrics available for Inflatable Hot Tubs. It is made up of a polyester mesh with a layer of reinforced PVC on either side.

Drain hot tub to the minimum mark and re-fill with fresh water to the maximum mark, this will help to dilute the excess chlorine. Remove the cover from Lay-Z-Spa to allow evaporation of the chlorine (keep the filter running constantly). pH measures how acidic or alkaline your water is and the ideal range for hot tubs is between 7.2 and 7.6. Balanced pH is necessary for other chemicals to work properly and imbalanced pH levels can impact your hot tub components and cause skin irritation. The Lay Z Spa St Moritz is an excellent choice of inflatable hot tub for large families or for people that are intending to invite several friends to come over and enjoy a premium hot tub experience. For high chlorine levels above 5ppm, we would suggest you drain the Lay-Z-Spa to the minimum mark and re-fill with fresh water to the maximum mark, this will help to dilute the excess chemical. Or, remove the cover from the hot tub to allow evaporation of the chemical (keep the spa filter running constantly).

Be in the know

We’ll give this one a four, simply because you can expect there to still be some charges to clear after only a short time. The timer system and pump are likely to cause a bit of cost here and there, but the fact you can ask your tub to come on at a certain time is surely going to save you money. Compare this with systems where you’d normally need to spend hours on end pumping and heating things up, and you’re onto a winner. However, do be aware that there is, of course, perhaps more of a cost to pay upfront than elsewhere. In our collective opinion, it’s more than worth it. Heat Up Times 5/5 Outdoor storage areas for your hot tub chemicals should be situated away from anything flammable. Keep any petrol-powered equipment, like your lawnmower, in a different location. The storage area should also be away from sources of heat, like an outdoor fire pit or BBQ. Total Alkalinity (TA) is the measure of your hot tub water’s ability to neutralise acids. Balanced Total Alkalinity helps control the pH levels and the correct level to aim for is between 80 and 120 parts per million (ppm).

Unfortunately, like with all Inflatable Hot Tubs, you cannot leave your pump unit outside in temperatures below 4oC when it is not heating, since the water inside the pump may freeze, expand, and cause damage to the internal parts. It is not waterproof – simply splash-proof, like the other Lay Z Spa pumps – so you’ll have to keep it covered in strong rain. For low pH levels below 7.2 you will need to use pH Plus to help raise the pH levels and balance the water. Chlorine demand of water too high at start up, after holidays or due to excess contamination or neglect The 5 Inch Chemical Floater slowly releases Clearwater Mini Multifunctional Tablets or Chlorine Tablets, making it the perfect accessory for busy spa users who want a hassle-free way of maintaining clear and healthy spa water. The dispenser has an adjustable dial which controls the release of the 20g tablets, ensuring that the sanitizer level of your spa water is consistently and efficiently maintained. Compatible with all spa models. For low TA levels below 80ppm you will need to use Total Alkalinity Increaser. The amount of TA + you need to add to your hot tub depends on the volume of water and how low your readings are. As a guide - a hot tub of 1,000 litres requires 18g to raise Total Alkalinity levels by 10ppm (parts per million).ClearWater® is our chosen and recommended chemical provider. Developed with Lay-Z-Spa in mind, the range of ClearWater® hot tub chemicals includes everything needed to make sure your Lay-Z-Spa's water stays safe, clean and clear. Explore the table below which includes each product’s use and function. Never use unlabelled chemicals and please read the instructions before use. Avoid getting chemicals in eyes, on skin or on clothing. Avoid breathing vapours when opening a container. Avoid creation of dust. Never add water to the product. Always add product to large quantities of water. Use separate clean dry utensils for each chemical and clean after use. Do not add the product to any dispensing device containing residuals of other products. It is important to get your hot tub Chlorine levels correct. Not enough Chlorine can result in unhygienic bathing conditions, whereas high Chlorine levels can cause irritated eyes or skin. Clearwater Clarifier contains flocculants which bind small particles of debris and algae together so that your Lay-Z-Spa filtration system can adequately remove them, resulting in clean and sparkly water. This is a very effective way of preventing your spa water from looking dull and cloudy, due to the build-up of dead algae and debris that is too small to be trapped by your filter. Even if you have treated your spa for algae using Clearwater Algaecide, it is recommended that you use the Water Clarifier to remove any residual debris.