This picture shows what can expected on flat paint. Notice how the brown has flowed down the panel lines? centered on flat blue This color was added to Panel Line Accent Color Series; it is ideal for highlighting panel lines and other details to give your model a more realistic depth. ★Dark Brown color is useful for applying weathering effects on tank models. ★1 bottle contains 40cc enamel paint. The bottle's cap features a brush for easy application. Lastly, I took the time to scribe the panel lines and rivet the rudder of the B-17 Flying Fortress. Then it was primed and sprayed light sky grey and given a mat clear coat. After the prep work had dried, I used the brown color to accentuate my detail work. Use the same method for removing the excess as explained above, yet for raised bolts and rivets a fine brush will allow you to get in between those without removing the needed accent color. Cup on part with brush

Apply over base coat of lacquer or acrylic paint. Accent Color paints may damage underlying base coat. Test before applying onto the model.

Lining Like a Pro 】　These enamel paints are ideal for highlighting panel lines and other details to give your model a more realistic depth. The paint has been pre-diluted into the ideal viscosity and can be easily applied into crevasses such as panel lines with the brush on the bottle cap. Once dried, any excess may be cleaned up by using enamel thinner. (Bottle contains 40ml)

Keep collections to yourself or inspire other shoppers! Keep in mind that anyone can view public collections - they may also appear in recommendations and other places. As you can see in the picture there’s quite a difference between the two color tones. The lighter looks as though rain had collected then dried while the softer brown has that earthy look. The point is you can have multiple shades and not be restricted to one. Tail with two cups And the same thing occurs with the semi and gloss coated sections. Now the all-important time to dry. centered on semi and gloss wing area Boeing B-52H Stratofortress, US Air Force, great for home, office or dorm, Paper, Canvas, Metal, Acrylic and triptych options Plastic parts may become brittle. Avoid using on movable parts and take care when applying to load-bearing areas.

Why us

Once these clear coats have fully dried in an hour or so the Tamiya Panel Line Accent Color can be safely added. It’s critical to let them dry or you risk rubbing the Tamiya pigment into the unhardened clear coat. Wing half with 3 sheens Now let’s get a little more organic. One of the great features about these products is blending it for a more idea shade. Sometimes light grey is too bold. In this picture you can see I’ve cut the ratio 50/50 in a mixing cup. This will give that spot a look of being hit by the muddy wind of propeller air-wash. Brown and grey in cup

Next, you’ll begin to remove the excess. Work 90 degrees against the direction of the line when you can. Rubbing the same direction will, in many cases, remove the wash entirely. Don’t press too hard, remember you’re just adding thinner. After a few strokes the pigment will rehydrate and begin coming away. Turn your cotton swab often to a clean spot and replace it when it’s covered with pigment. Blue arrows on tailTamiya Masking Tape Holder - Holds 6, 10 and 18mm wide rolls with Anti-Slip Rubber Feet - Easy to swap out with Magnetic Top - 3D Printed With the wing part in full view, you can clearly see that uncoated wing tip area refused to give up all the pigment, leaving a brown hue. Notice the difference below on the clean aileron? Once again, it all boils down to which look you want. Be cautious, rubbing too much on bare paint will remove some of it. full blue wing part Notice the difference between the pronounced detail in the lower part of the picture vs the bland upper half of the photograph? A much-improved look, something simple to do and takes very little time to pull off. Tamiya Panel Liner Completed Application