The UniFi FlexHD is a dual-band AP, with a 2.4GHz 2x2 MIMO radio and a 5GHz 802.11ac-Wave2 4x4 MU-MIMO radio. The AP is powered via 802.3af PoE, using a single Gigabit Ethernet port located near the base. Ready to Mesh Thanks to its discreet design, the UniFi FlexHD can be mounted near users without compromising a location's aesthetic. The FlexHD can be deployed almost anywhere; on a desktop, on a wall or a pole, or even in the ceiling (special mount required - available separately).

The Cloud Keys are different. They are not gateways or routers, they only run UniFi OS applications. I’m including them to make comparing which models run which UniFi OS applications easier. Cloud Keys require the use of the USG, USG-Pro, UXG-Lite, UXG-Pro, or some 3rd party router or firewall. MU-MIMO: Assuming the same conditions, a Wave 2 AP provides up to 75% improvement overall over a Wave 1 AP. This improvement increases wireless performance and/or serves more clients at the same performance level. A 4x4 Wave 2 AP delivers up to 33% greater performance than a Wave 1 AP that is 3x3 in both radio bands. High-Density Scenarios Best mesh Wi-Fi 2021: banish dead spots and boost your broadband How to boost your business Wi-Fi Ubiquiti Networks UniFi nanoHD review: Software-defined networking on a budget Upgrade your wireless APs Zyxel Multy Plus review: SMB-friendly mesh Wi-FiShielded Category 5 (or above) cabling should be used for all outdoor wired Ethernet connections and should be grounded through the AC ground of the PoE.

Please note: If you are mounting the UAP-FlexHD outdoors, it must be installed in the upright position, with the Ubiquiti logo facing up, to prevent water from getting into the base of the device. We'll start by looking at all of the current options for UniFi gateways, including some older ones that Ubiquiti no longer lists on their official store. Current GatewaysSpatial Streams At any single time, a Wave 2 AP can communicate with the following MU-MIMO clients: Note: If you are mounting the UAP-FlexHD outdoors, it must be installed in the upright position to prevent water from getting into the base of the device. Note: When installing Ethernet cabling on a pole or up the outer surface of a wall, use RJ45 connectors without strain-relief boots on them. This will prevent unnecessary tension on the cable ends. It’s also possible to monitor your wireless networks on the move, thanks to Ubiquiti’s free iOS and Android mobile apps. With the former loaded on our iPad, we were able to log into our cloud account in moments, and gain access to all of the same monitoring features that are available in the UNC console. When it comes to a small and sleek form factor, the UniFi FlexHD Access Point is one of the smallest and sleekest Access Points on the market. Less than 160mm tall, and with a diameter of only 48.5mm, the UniFi FlexHD can be deployed almost anywhere and deliver exceptional wireless performance, even outdoors. Enterprise-Ready Performance

Initial 802.11ac Wave 1 SU-MIMO (Single-User, Multiple Input, Multiple Output) technology allows an earlier-generation AP, such as the UniFi AC Pro AP, to communicate with only one client at a time. 802.11ac Wave 2 MU-MIMO (Multi-User, Multiple Input, Multiple Output) technology allows a Wave 2 AP, such as the UAP-FlexHD, to communicate with multiple clients at the same time – significantly increasing multi-user throughput and overall user experience. The following describes a 4-client scenario:We will not sell, distribute or lease your personal information to third parties unless we have your permission or are required by law to do so. We may use your personal information to send you promotional information about third parties which we think you may find interesting if you tell us that you wish this to happen.