I simply took out the mains cable from the old transformer and connected it to the bottom of the Ring transformer, I then took the doorbell cables from the chime and connected it to the top of the transformer and finally I mounted it in a din rail enclosure. com/hc/en-us/articles/115000148786-Ring-Video-Doorbell-Pro-European-Version ,so needs to go into a CU. Using a transformer to supply a lower load than the nominal power reduces the power loss containing the temperature rise of a bell transformer used continuously. If that is the case then there's no way I'll be able to neatly get a cable from the CU to the front door. But they can't tell me why and I am losing faith that they have any idea what they are talking about!

Therefore using a bell transformer for continuous use determines a temperature rise of the transformer which could cause it to stop supplying power, unless the work/pause cycle allows the transformer to sufficiently cool down.We are one of the largest independent electrical wholesalers in the West Midlands, with distribution centres in Leicester, London, Manchester and Newcastle-Upon-Tyne. Maybe the best approach is to decide the best location of the Ring transformer (in/by existing consumer unit, placed in existing bellbox, new housing at bellbox location).

We then had the new Ring transformer fitted (at the same time as a Ring doorbell), and it solves the noise problem. There are reviews that criticise it for not being compatible with the standard consumer unit busbar. Will the Honeywell Ding Dong 117 work with the Doorbell Wired when powered by the DIN Rail Transformer (2nd Gen), or should I be using a different chime in the UK? I'm sure that would be fine, but I was glad I didn't have to deal with all of the wiring in the Consumer Unit as doing that as a non registered electrician could be considered risky. New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging .

Unfortunately i don't have enough space in my consumer unit to house it (it needs 2 slots, i only have 1 ).

Disconnect power to the installation area at your circuit breaker or fuse box before beginning installation. It does however perform well and was easy to install is not too unsightly but could be made to look more subtle such as a white colour. It may be worth avoiding having a bellbox completely as it will not be used once you have the Ring Doorbell (+Chime).Or could I remove the whole box shown in the picture and replace it with the transformer + enclosure (i.

Read more about the condition New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging is applicable). If you have an existing doorbell, your new device can be installed with the included Din-Rail Transformer.I'll be getting a simple dumb wired doorbell but I want to make sure it is future proofed so I can install a Ring Pro 2 in the not too distant future (this is a hardwired variant of the Ring doorbell). If, like most doorbells in Europe, your doorbell only works at 8-12 Volts AC, your existing transformer won't have enough power to support your Ring device, and will need to be replaced by the included 24 Volt Ring transformer.